Skip to content

Concrete slabs for a sauna: size, thickness and curing

Last checked November 17, 2026

Makers don't agree on one slab thickness. They agree on the shape of the job: a flat, reinforced slab on compacted gravel, left to cure before the sauna arrives.

The word "cure" trips up beginners, so start there.

What curing means

Curing is the hardening time a fresh slab needs before it's ready for load. Wikipedia says proper curing of ground-bearing concrete is necessary to obtain adequate strength1. SaunaFin warns that a fresh pour requires time to cure properly2.

Think of baking bread. If you pull it out at the halfway point, it looks fine outside and isn't done inside.

How long to wait

The numbers differ, and they're worth comparing.

Source Cure time given
Sun Home Saunas Curing (3–7 days)3
Haven of Heat At least 7 days before placing the sauna4
Peak Saunas 28 days, with 7 days called the absolute minimum5

Why the gap? These are different companies writing for different products. Your maker's manual is the number to follow.

How thick?

Again, a range.

Source Thickness
Almost Heaven Ideal thickness of 3-4 inches with proper leveling6
Sun Home Saunas 4 inches, reinforced, on compacted gravel3
Haven of Heat A minimum 4-inch slab4

The common thread is about 4 inches, though Almost Heaven's range starts lower6. Your maker's manual may ask for something different for your model, so check it before you order concrete.

What a pour involves

Haven of Heat lists the steps: excavating, adding a compacted gravel sub-base, setting forms, placing rebar or wire mesh, and pouring the slab4. Forms are the temporary wooden walls that hold wet concrete in shape. Rebar is the steel rod that reinforces it.

Haven of Heat calls a slab ideal for large cabin saunas or pre-assembled outdoor saunas that won't be moved4. SaunaFin says concrete gives a sturdy, flat, pest-proof surface, but that it can cost more and needs time to cure2.

In short, think of concrete as the choice for a sauna you plan to leave where it is.

What goes under the slab

Sun Home Saunas lists reinforced concrete on compacted gravel3. Peak Saunas lists a compacted gravel layer of 2–3 inches under its slab5.

Wikipedia adds that leveling the site before pouring is an important step, since sloping ground makes concrete cure unevenly1.

How big?

Make the slab larger than the sauna's footprint. By how much depends on the maker and on your layout. The next page, sizing the base to the sauna, compares the figures.

A shortcut worth knowing

You don't have to pour. SaunaFin points out that you can purchase premade concrete pads, and calls one an excellent sauna base once it's laid down and leveled off2.

Before you commit

A slab is hard to undo. If it's poured in the wrong place or at the wrong size, you break it up. Read the sauna's manual first, check any local rules, and measure twice. For a softer option, see gravel pads.

Order of work for a poured slabLevel and compact the gravelSet forms and reinforcementPour and finish the concreteLet it curePlace the sauna
Curing comes before the sauna does.

Notes and sources

  1. Concrete slab, Wikipedia
  2. How to Prep the Base for Your Outdoor Sauna, SaunaFin
  3. Outdoor Sauna Installation Guide, Sun Home Saunas
  4. How to Level Ground for an Outdoor Sauna, Haven of Heat
  5. Outdoor Infrared Sauna Installation Guide, Peak Saunas
  6. How to Prepare Your Space for an Outdoor Sauna, Almost Heaven Saunas