Skip to content

Sizing the base to the sauna: footprint, overhang and clearances

Last checked November 17, 2026

The base should be bigger than the sauna. How much bigger depends on who you ask, which is why you start with the maker's own dimensions.

One idea at a time.

Idea one: footprint means the widest part

The footprint is the patch of ground the sauna covers. Many outdoor saunas have a roof that sticks out past the walls. Sun Home Saunas says to measure for the full footprint including the overhang, not just the cabin1. Haven of Heat says the same for cabin saunas: the leveled area should account for the full structure plus overhang2.

An example. A sauna's walls are narrower than its roof. If you measure the walls and build to that, the roof edge hangs over the gravel's border. Measure the roof.

Idea two: the base has to reach every support

SaunaSpa lists a basic test: the base is large enough to support every cradle, skid or support rail3. It also says to get the exact exterior dimensions and the support layout before you begin the foundation3. Those come from your model's documents, not from a guess.

Idea three: add a margin

Two different figures get called a "margin." Keep them apart.

Pad extent: how far the pad reaches past the sauna

Source What it says
Haven of Heat A pad that extends at least 12 inches beyond the sauna on all sides is the minimum2
Haven of Heat When marking the work area, measure at least 2 feet wider than the sauna on all sides2

Clearance: open space around the sauna

Source What it says
Sun Home Saunas Leave 4–6 inches of clearance on all sides and 20–24 inches above the roof1
Sun Home Saunas, another guide Allow 2–6 inches on the sides and back, plus room in front to open the door fully4

The clearance figures are not pad margins. Don't use them to size the pad.

If your own maker gives a pad figure, use it. Where it gives none, use the pad-extent figures above, and write down which source you followed.

Idea four: leave room for the door

SaunaFin says to pick a spot with enough space for the door to open and close comfortably5. Plan the base so the entrance has somewhere to stand.

A worked sequence

  • Get the exact outside dimensions, roof included, from the manual.
  • Note where the supports sit.
  • Add the pad margin your maker names. If none, take it from the pad-extent figures, not the clearance figures, and note the source.
  • Add the door side.
  • Mark the outline on the ground and check it before you dig.

Gravel and slab pages have their own details: see gravel pads and concrete slabs. Once the size is set, leveling the base is next.

Working out the base sizeRead the maker's exact dimensionsFind the widest part, roof includedAdd the pad margin your maker asks forAdd door and walking room
Start from the roof, not the walls.

Notes and sources

  1. Outdoor Sauna Installation Guide, Sun Home Saunas
  2. How to Level Ground for an Outdoor Sauna, Haven of Heat
  3. Outdoor Sauna Installation in Canada, SaunaSpa
  4. How to Prepare Your Space, Sun Home Saunas
  5. How to Prep the Base for Your Outdoor Sauna, SaunaFin