Skip to content

Leveling a sauna base and checking it stays level

Last checked November 17, 2026

A sauna base should be as level as the maker asks, and the maker's number beats any number you read online. Two companies give figures here, and they're written in different ways.

Why level matters

Peak Saunas says even a small variance across a 6-foot span causes door gaps, panel warping and long-term frame stress1. Sun Home Saunas says small variations can affect door alignment and panel fit2. Almost Heaven says to double-check leveling to prevent structural stress3.

Think of a table with one short leg. The tabletop twists a little every time you lean on it. A sauna cabin does the same, only heavier.

What the makers accept

Source Tolerance or check
Haven of Heat Level within 1/4 inch across the full span of a gravel pad4
Peak Saunas Tolerance of 1/8 inch per 4 feet when laying base panels, checked in 4 directions1

The two figures aren't the same, and they're measuring different things. One is for a pad's whole span. The other is for the sauna's base panels. Your manual's figure is the one to use.

The tools

Sun Home Saunas recommends a 4 ft level for accuracy2. Haven of Heat also uses a long straightedge, such as a straight board, with a level on top4. LSU AgCenter's guide, written for patios, shows a string method for bigger areas5.

Check method one: straightedge and level

Lay the straightedge across the surface and put the level on it. Haven of Heat says to check for level in multiple directions with a long straightedge, then add or scrape away gravel and compact again4. Don't just check along the length. Turn it across, and corner to corner.

Check method two: string

For a larger area, LSU AgCenter ties a string between rebar rods set at the corners, and uses a hanging line level to make sure the string is level5. Measure from the string down to the surface at several points. The numbers should match.

One catch. LSU's patio guide sets the surface at a slope on purpose, so that water runs away from buildings. A sauna base has different needs. If a maker wants it level, level is the target.

Fixing small errors

Sun Home Saunas says to place shims under the base frame only, and not between wall panels2. It also warns against using soft or compressible materials as shims2. A shim is a thin wedge or plate used to raise one low spot.

Does a floor that looks flat need a check? Sun Home Saunas says yes: always confirm with a level2.

Checking again later

A base can change after you've built it. Peak Saunas puts a gravel base on a six-month schedule, with a re-level whenever the stone settles1. Put a reminder on your calendar. For how a gravel pad is built so it holds, see gravel pads. For the slab version, see concrete slabs.

A level check for the baseLay a straightedge on the baseSet the level on topRead it in several directionsFix high and low spotsRe-check after assembly
Check before the sauna goes on, and again later.

Notes and sources

  1. Outdoor Infrared Sauna Installation Guide, Peak Saunas
  2. How to Level Your Sauna, Sun Home Saunas
  3. How to Prepare Your Space for an Outdoor Sauna, Almost Heaven Saunas
  4. How to Level Ground for an Outdoor Sauna, Haven of Heat
  5. Best Practices for Paver Installation, LSU AgCenter