Gravel pads for a sauna: layers, depth and edging
A compacted gravel pad is a layer of crushed stone, packed tight, held in by an edge. Makers list it as a regular option for an outdoor sauna. Almost Heaven describes gravel as easy to install and says it lets water run off naturally1.
Here's how the layers go, one idea at a time.
Start with bare ground
Take off the grass first. LSU AgCenter's paver guide says to remove grass from the work area2. That guide is about patios, not saunas, but the ground rule is the same: gravel shouldn't sit on a mat of living turf that rots and sinks.
Haven of Heat adds roots, rocks and other organic debris to the list3.
Choose the right stone
Not all gravel packs down. Haven of Heat says to use 3/4-inch crushed gravel, because angular stone locks together when it's compacted. It says to avoid round river rock or pea gravel for the base3.
Picture a bucket of marbles next to a bucket of broken glass. Push down on each. The marbles roll. The sharp pieces catch each other. Crushed stone behaves like the glass.
How deep?
Sources give a range, not one number.
- Almost Heaven says to use crushed stone or gravel at least 4-6 inches deep1.
- Haven of Heat aims for a total compacted depth of 4 to 6 inches3.
If your sauna maker gives a depth, use theirs.
Add it in thin layers
Don't dump it all in at once. Haven of Heat fills the dug-out area in 2-inch lifts, which are thin layers, and compacts each one before adding the next3. LSU AgCenter uses a vibratory plate compactor to pack gravel into a smooth surface2.
A hand tamper is a flat plate on a pole. A plate compactor is a small machine that vibrates. Haven of Heat says a plate compactor is highly recommended for larger pads3.
Set the edging
Gravel spreads sideways unless something holds it. Haven of Heat says the top of the edging should sit at or just above the planned finished surface of the pad3. Peak Saunas mentions pressure-treated beams as the frame4.
Know the weak spot
SaunaFin gives the trade-off: gravel is cost-effective and drains well, but it can shift over time, leading to an uneven surface5. Peak Saunas suggests checking every 6 months and re-leveling as the gravel settles4.
So a gravel pad isn't a one-time job. Plan to look at it now and then.
When gravel may not be enough
Heavier saunas put more weight on the pad. Check your maker's manual for the loaded weight and for its base advice. If it asks for concrete, see concrete slabs for a sauna. For how far the pad should reach past the walls, read sizing the base.
Notes and sources
- How to Prepare Your Space for an Outdoor Sauna, Almost Heaven Saunas
- Best Practices for Paver Installation, LSU AgCenter
- How to Level Ground for an Outdoor Sauna, Haven of Heat
- Outdoor Infrared Sauna Installation Guide, Peak Saunas
- How to Prep the Base for Your Outdoor Sauna, SaunaFin